The old Windows 3x "Terminal.exe" (runs OK on No affiliation, but I use it on several Windows machines at work, andįind it one of, if not the best of such tools.įor Windows 3x diehards. (Can also do LAN based Telnet stuff too, if you have to.
Keyspan usa 19hs driver for windows 7 serial#
It's scriptable, and you can setup banks of programmed buttons forĬommon functions on serial controlled gear (radios and such).Īt first sight it looks over complicated, but play with it, and you'll VERY good, lots of options in the sending and receiving format, plus If you need a good and flexible terminal program for Windows 10 (or 7) It's weird that the exact same hardware has problems in a different OS. Yes, Device Manager sees the Keyspan adapter as COM3 for both OS's and checked it is set for 38400. On 19:12, Don Degidio via groups.io wrote: Have the wrong serial port parameters like baud rate. That error message implies that either the COM port cannot beįound, it could be in use by another application, or you might Looked through other group messages for a solution and found
Keyspan usa 19hs driver for windows 7 drivers#
I have installed the Win7 drivers for Keyspan adapter. When came time to test CAT getĮrror "Hamlib error: IO error while opening connection to rig". Start Win7U 64bit and installed correct 2.2.2 and used identical
Win7U 64bit after shutting down computer. Have trays for SSD's so that I can switch between Win XP and Tab Input and Output set to USB AUDIO CODEC. Handshake Hardware, Mode Data/Pkt, Split Operation Rig. Here's those settings: Radio Tab Rig Yaesu FT-450, Cat ControlĬOM3 38400, PTT Method Cat, Data Bits Eight, Stop Bits One, Running 2.1.2 on desktop PC with WinXP SP3Īnd FT-450 using SignaLink USB and Keyspan USA-19HS USB - RS232 That error message implies that either the COM port cannot be found, it could be in use by another application, or you might have the wrong serial port parameters like baud rate. I have looked through other group messages for a solution and found none.
When came time to test CAT get error "Hamlib error: IO error while opening connection to rig". Start Win7U 64bit and installed correct 2.2.2 and used identical settings as for 2.1.2 in Win XP.
Have trays for SSD's so that I can switch between Win XP and Win7U 64bit after shutting down computer. Audio Tab Input and Output set to USB AUDIO CODEC. Here's those settings: Radio Tab Rig Yaesu FT-450, Cat Control COM3 38400, PTT Method Cat, Data Bits Eight, Stop Bits One, Handshake Hardware, Mode Data/Pkt, Split Operation Rig. Running 2.1.2 on desktop PC with WinXP SP3 and FT-450 using SignaLink USB and Keyspan USA-19HS USB - RS232 (COM3) for rig control. On 16:54, Don Degidio via groups.io wrote: